|
Tractive effort is the pulling force exerted, normally by a locomotive, though the term could also be used for anything else that hauls a load. It is normally understood to
be the actual force on the locomotive's drawbar or rear coupler. When
a bare figure for tractive effort is quoted without a speed qualification, this is normally for starting tractive
effort, i.e. at a dead start with the wheels not turning.
In most cases, especially for [steam locomotive]s, this figure is a calculated, not measured one. The normal formula used
(measurements in pounds and inches) is:
-
where
- t is tractive effort
- c is a constant representing losses in pressure and friction; normally 0.85 is used
- P is the boiler pressure in pounds per square inch
- d is the piston diameter (bore) in
inches
- s is the piston stroke in inches
- D is the driving wheel diameter in inches
The constant 0.85 was the AAR
standard for such calculations, and certainly over-estimated the efficiency of some locomotives and underestimated that of
others. Modern, roller bearing fitted locomotives were probably underestimated in this calculation.
European designers used a constant of 0.6 instead of 0.85, so the two cannot be directly compared without a conversion
factor.
Tractive effort is the figure most often quoted when people are comparing the power of different steam locomotives, but the use can be misleading, because tractive effort
shows the ability to start a train, not the ability to do work by hauling it. Possibly the highest figure for starting tractive
effort ever recorded was for the Virginian Railroad's 2-8-8-8-4 Triplex locomotive, which in simple expansion mode had a
starting T.E. of 199,560 lb (888 kN) — but this did not translate into power, for the boiler was undersized and could not
produce enough steam to haul at speeds over 5 mph (8 km/h).
Of more successful large steam power, the Union Pacific's famous
Big Boys had a starting T.E. of 135,375 lb (602 kN), the
Norfolk &
Western's 2-8-8-2 Y6a had a
starting T.E. of 152,206 lb (677 kN) in simple expansion mode, and the Pennsylvania Railroad's freight Duplex Q2 attained 114,860 lb (511 kN) — the highest for a rigid framed locomotive. Later two cylinder passenger
locomotives were generally 70,000 to 80,000 lb (300 to 350 kN) of T.E.
For a diesel-electric or electric locomotive, starting T.E. can be calculated from the stall torque of the traction motors (the turning force it
can produce while at a dead stop), the gearing, and the wheel diameter.
A related statistic is a locomotive's factor of adhesion,
which is simply the weight
on the locomotive's drivers divided by the starting tractive effort.
|