|
A steam turbine extracts the energy of dry pressurized superheated steam as mechanical movement. Energy is force acting over distance. In a Parsons-Westinghouse steam turbine nozzles apply supersonic steam to a curved blade. The blade whips the steam back in
the opposite direction, simultaneously allowing the steam to expand a bit. A stationary blade then redirects the steam at the
next blade. The process repeats until the steam is completely expanded. The moving blades are mounted radially on the rotor. The
stationary blades are mounted to the case of the turbine.
Steam turbines of this type have some weak spots. First, some steam leaks through the annulus where the of the shaft
penetrates the casing. Usually this is limited by some sort of rotating labyrinth seal, but it can be a problem, especially on the high-pressure end of the turbine. Also, most
steam turbines are very particular about what they expect in their feed. Water droplets can quickly damage a steam turbine if the
turbine blades have not been designed to withstand the presence of water droplets.
The turbine described above was invented by Charles A.
Parsons, and improved by George Westinghouse.
A number of other types of turbines have been developed that work effectively with steam:
The de Laval turbine (invented by Gustaf de Laval) accelerated the
steam to full speed before running it against a turbine blade. This was good, because the turbine is simpler, less expensive and
does not need to be pressure-proof. It can operate with any pressure of steam. It is also, however, less efficient.
Problems with turbines are quite rare but any imbalance of the rotor blades can lead to vibration, which in extreme cases can
lead to a blade letting go and punching straight through the casing. If water gets into the gas and is blasted onto the blades
rapid erosion of the blades can occur, possibly leading to imbalance and failure. The control of a turbine with a governor is
essential, as turbines need to be run up slowly, to prevent damage. Uncontrolled acceleration of the turbine rotor can lead to
the overspeed trip being activated to shut off the activating gas supply to the turbine. If this fails then the turbine may
continue accelerating until it breaks apart, often spectacularly, probably extremely dangerously. The high pressures inside the
casing lead to problems in sealing the output shaft(labyrinth seals). Turbines are expensive to make, requiring precision
manufacture and special quality materials. This purchase cost is offset by much lower maintenance requirements and the small size
of a turbine when compared to its shaft power output. Electrical Power stations around the world use large steam turbines driving
turbo-generators to produce vast amounts of electricity.
|