|
Relay as used in cars
A relay is an electromechanical switch that uses an electromagnet to open or close one or many sets of contacts.
When a current flows through the induction coil, the resulting magnetic field attracts an armature that is mechanically linked to a moving contact. The movement either
makes or breaks a connection with a fixed contact. When the current is switched off, the armature is returned by a spring to its resting position.
Applications
Relays are used:
- to control a high-voltage circuit with a low-voltage signal, as in some types of
modem,
- to control a high-current circuit with a low-current signal, as in the starter solenoid of an automobile,
- to isolate the controlling circuit from the controlled circuit when the two are at different potentials, for example when
controlling a mains-powered device from a low-voltage switch.
- to perform logic functions. For example, the boolean AND function is realised by connecting relay contacts in series, the OR
function by connecting contacts in parallel.
Small relay as used in electronics
Types of relay
A changeover relay has one moving contact (common or C) and two fixed contacts. One of these is Normally
Closed (NC) when the relay is switched off, and the other is Normally Open (NO). Switching the relay on causes the normally open
contact to close and the normally closed contact to open.
A latching relay is mechanically arranged so that the armature can rest in either of two positions. There are
two coils that pull the armature in opposite directions, so the relay can be switched to one position or the other and then left
in that state indefinitely. This type of relay has the advantage that it consumes power only for an instant, while it is being
switched.
A reed relay has two, usually normally open, contacts inside a vacuum or inert gas filled glass tube. This protects the contacts
against atmospheric corrosion. The two contacts are closed by magnetism from a
coil around the glass tube, or a permanent magnet moved towards it. See also: reed switch.
Reed relay and reed switches
A relay can be made into a buzzer by wiring up the coil in series with the normally closed contacts. When a current is applied
to the relay, it opens the contacts that provide current to the coil, causing the current to stop flowing and the contacts to
close again. This cycle repeats continuously, causing the relay to buzz at an audible frequency.
Relay is also the name of a series of medium-altitude satellites; the first was launched in 1962.
See also:
|