|
Plaster of Paris, or simply plaster, is a type of building material based on calcium sulfate
hemihydrate, nominally (CaSO4)2. H2O. It is created
by heating gypsum to about 150°C, 2(CaSO4.2
H2O) => (CaSO4)2 .H2O
+ 3 H2O (released as steam). A large gypsum deposit at Montmartre in Paris is the source of the name. When the dry plaster
power is mixed with water, it re-forms into gypsum, initially as a paste but eventually drying into a solid. The structure is
made up of sheets of Ca2+ and SO42- ions held
together by hydrogen bonds in the water molecules. The grip between these
sheets is easily broken, so plaster is fairly soft.
Plaster is used as a building material similar to mortar or
cement. Like those materials plaster starts as a dry powder that is mixed with water to
form a paste, which then dries into a hard surface. Unlike those materials plaster remains quite soft after drying, and can be
easily manipulated with metal tools or even sandpaper. Plaster was a common
building material for wall surfaces in a process known as lath and plaster, in which a series of wooden strips were covered with a semi-dry plaster and
then hardened into a flat surface. Today this building method has been almost completely replaced with drywall.
Plaster expands while drying, then contracts slightly just before hardening completely. This makes plaster excellent for use
in molds, and it is often used as an artistic material for casting. Plaster is also commonly spread over an armature (form),
usually made of wire, mesh or other materials. In medicine, it is also widely used as a support for broken bones; a bandage
impregnated with plaster is moistened and then wrapped around the damaged limb, setting into a close-fitting yet easily removed
tube.
Many early buildings in Paris, Ontario were made with abundant
amounts of this material, hence the town's name.
Lime plaster is a mixture of calcium hydroxide and river sand (or other inert fillers). Carbon dioxide in the
atmosphere causes the plaster to set by transforming the calcium hydroxide into calcium carbonate (limestone). Whitewash is based on the same chemistry.
Calcium hydroxide is produced by heating calcium carbonate (limestone) to
produce calcium oxide (quicklime). Water is then added to produce calcium
hydroxide (slaked lime).
Lime Plaster is used for true frescos; where pigments, without the addition of any kind of medium, just diluted in water, are
applied to the still wet plaster before it sets. The pigments bind right into the plaster itself.
|