|
Computer generated image of Global Surveyor spacecraft (NASA)
The launch of the Mars Global Surveyor (MGS) spacecraft in
November 1996 by NASA and the Jet Propulsion Laboratory began America's return to Mars after a 20-year absence.
The Surveyor spacecraft, fabricated at the Lockheed Martin
Astronautics plant in Denver, is a rectangular-shaped box with
wing-like projections extending from opposite sides. When fully loaded with propellant at the time of launch, the spacecraft
weighed only 1,060-kilograms (2,342 pounds). Most of Surveyor's mass lies in the box-shaped module occupying the center portion
of the spacecraft. In reality, this center module is made of two smaller rectangular modules stacked on top of each other. One of
the two smaller modules, called the equipment module, holds all of the spacecraft's electronics and science instruments. The
other, called the propulsion module, houses Surveyor's rocket engines and propellant tanks.
Mission chronology
The Surveyor spacecraft was launched from the Cape Canaveral Air Station in Florida on November 7, 1996 aboard a Delta-7925 rocket. The spacecraft travelled
nearly 750 million kilometers (466 million miles) over the course of a 300-day cruise to reach Mars on September 11, 1997.
Upon reaching Mars, Surveyor fired its main rocket engine for the 22-minute Mars orbit insertion (MOI) burn. This
maneuver slowed the spacecraft and allowed the planet's gravity to capture it into orbit.
Initially, Surveyor entered a highly elliptical orbit that took 45 hours to
complete. The orbit had a periapsis of 262 km above the northern hemisphere, and
an apoapsis of 54,026 km above the southern hemisphere.
After orbit insertion, Surveyor performed a series of orbit changes to lower the periapsis of its orbit into the upper fringes
of the Martian atmosphere at an altitude of about 110 kilometers (68 miles). During every atmospheric pass, the spacecraft slowed
down by a slight amount because of air resistance. This slowing caused the spacecraft to lose altitude on its next pass through
the orbit's apoapsis. Surveyor used this aerobraking technique over a period
of four months to lower the high point of its orbit from 54,000 kilometers to altitudes near 450 kilometers.
On October 11 The flight team performed a maneuver to raise the periapsis
out of the atmosphere. This suspension of aerobraking was performed because air pressure from the atmosphere caused one of
Surveyor's two solar panels to bend backward by a slight amount. The panel in
question was slightly damaged shortly after launch in November 1996. Aerobraking was resumed on November 7 after flight team members concluded that aerobraking was safe, provided that it occurs at a more
gentle pace than proposed by the original mission plan.
This image taken by Mars Global Surveyor spans a region about 1500 meters across, showing gullies on the walls of Newton Basin in
Sirenum Terra. Similar channels on Earth are formed by flowing water, but on Mars the temperature is normally too cold and the
atmosphere too thin to sustain liquid water. Nevertheless, many scientists hypothesize that liquid groundwater can sometimes
surface on Mars, erode gullies and channels, and pool at the bottom before freezing and evaporating.
Under the new mission plan, aerobraking occurred with the low point of the orbit at an average altitude of 120 km, as opposed
to the original altitude of 110 km. This slightly higher altitude resulted in a decrease of 66% in terms of air resistance
pressure experienced by the spacecraft. During these six months, aerobraking reduced the orbit period down to between 12 to 6
hours.
From May to November 1998, aerobraking was temporarily suspended to allow the orbit to drift into the proper position with
respect to the Sun. Without this hiatus, Surveyor would complete aerobraking with its orbit
in the wrong solar orientation. In order to maximize the efficiency of the mission, these six months were devoted to collecting
as much science data as possible. Data was be collected between two to four times per day, at the low point of each orbit.
Finally, from November 1998 to March 1999, aerobraking continued and shrank the high point of the orbit down to 450 km. At
this altitude, Surveyor circled Mars once every two hours. Aerobraking was scheduled to terminate at the same time the orbit
drifted into its proper position with respect to the Sun. In the desired orientation for mapping operations, the spacecraft
always crossed the day-side equator at 2:00 p.m.(local Mars time) moving from south
to north. This geometry was selected to enhance the total quality of the science return.
During mapping operations, the spacecraft circled Mars once every 118 minutes at an average altitude of 378 kilometers (235
miles). After mapping finishes, the spacecraft will function as a communications satellite to relay data back to Earth from
surface landers launched as part of future Mars missions.
Related articles
External links
|