|
An inductor is a passive electrical device that stores energy in a
magnetic field, typically by combining the effects of many loops of
electric current.
Inductors
Physics of the inductor
Construction
An inductor is usually constructed as a coil of conducting material, typically copper wire. A core of ferrous material is sometimes used, which
increases the inductance. Inductors can also be built on integrated
circuits using the same processes that are used to make computer chips. In these cases, aluminum is typically used as the
conducting material. However, it is rare that actual inductors are built on ICs; practical constraints make it far more common to
use a circuit called a "gyrator" which uses a capacitor to behave as if it were an
inductor.
Smaller inductors used for very high frequencies are sometimes made with a wire passing through a ferrite cylinder or bead.
Inductance
Inductance is a physical characteristic of an inductor. See inductance.
Energy
The energy (measured in joules, in SI) stored in an inductor is equal to the amount of work required to establish the current flowing
through the inductor, and therefore the magnetic field. This is given by:
-
where I is the current flowing through the inductor.
In electric circuits
An inductor only resists changes in current. An ideal inductor does not offer any resistance to direct current, except when the current is switched on and off, in which case it makes the change more
gradual. However, all real-world inductors are constructed from material with finite electrical resistance, which opposes even direct current.
When a sinusoidal alternating current (AC) flows through
an inductor, a sinusoidal alternating voltage (or electromotive
force, abbr. emf) is induced. The amplitude of the emf is related to the amplitude of the current and to the frequency of the
sinusoid by the following equation.
-
where ω is the angular frequency of the sinusoid
defined in terms of the frequency f as
- ω = 2πf
- ω = 2πf
Inductive reactance is defined as:
- XL = ωL = 2πfL
where XL is the inductive reactance, ω is the angular frequency, f is the frequency in Hertz, and
L is the inductance.
Inductive reactance is the positive imaginary component of impedance.
The complex impedance of an inductor is then given by:
- Z = jωL = j2πfL
where j is the imaginary number.
Inductor networks
Inductors in a parallel configuration
each have the same potential difference (voltage). To find their total equivalent inductance (Leq):
-
-
The current through inductors in series
stays the same, but the voltage across each inductor can be different. The sum of the potential differences (voltage) is equal to
the total voltage. To find their total inductance:
-
-
Applications
An induction coil is closely related to electromagnets in structure,
but used for a different purpose; to store energy in a magnetic field.
Because of their ability to alter AC signals, inductors are used extensively in analog electronics and signal processing, including radio reception and broadcasting. As the inductive reactance
XL changes with frequency, an electronic filter can
use inductors in conjunction with capacitors and other components to filter out
specific parts of the frequency spectrum.
Two (or more) coupled inductors form a transformer, which is a fundamental
component of every national power grid.
History
In 1885, William Stanley, Jr. built the first practical induction coil based on Lucien Gaulard and John Gibbs' idea. It was the precursor of the modern transformer.
See also
Electricity, Electronics, Capacitor, Transformer, Gyrator
Synonyms
coil, induction coil, choke, reactor
|